nhpowershift.org

Posts Tagged ‘accesories’

The car is already equipped with redundant audio device would need extra electricity. If still rely on standard batteries, then it makes the supply is not prime.

For example, a car has an innate 12-volt battery with current of 30 amperes. This means that the power produced is 360 watts. In other cases, the car is already using large watt halogen lamps with. In addition, the power amplifier to boost the audio system installed in the cabin.

If one assumes, 260-watt halogen lights, horn 140 watts and 300 watts of power amplifiers, the total is 700 watts. Meanwhile, an belonging to 360 watts of power. This means less than 340 watts. As a result, the battery quickly come up short.

There are 6 requirements for electrical systems and equipment flowing audio excellence.

• Alternator.
This component should be able to fill the battery. For that, consider the cleanliness of cables. If you already use the spec to SPL, alternator replacement shall be done so that the system can be used to supply a large electric currents.

• Storage Battery.
When equipped with an audio system, that meant adding electrical load, much less rely on the power of audio. If previous uses 40 ampere battery, it is now replaced it with a battery 60 ampere size.

• Battery Cables.
The bigger the size of the battery cable, then the better because of the easier flow of electric current. More importantly, the positive and negative cable should be the same.

• Cable “Ground”.
Ground the chassis must be sanded before the negative cable was installed. Usually, the best and strongest point is the position seatbelt. Addition of ground wires is very effective to create an electric current is stable. That is, from the negative battery, it can be distributed to body, engine, alternator negative, and others.

• “Cap Bank”.
This device is also not good to lose its role to achieve a stable flow. Through a component that serves as the current store, the electricity will always be properly distributed. Counts for the bank stamp, 1 farad for 1000 watts. To be safer, use specification 2 farad.

• “Batcap”.
If you want an electric current is more stable again, we can use batcap Xstatic. This product consists of several types, namely, X300, X400, X800, and x2000. These components combine battery and a bank stamp. With large reservoirs, which flows out of large, stable, and fast.

Accessories are one of the devices currently in folowed by classic retro car fans is the “spoiler”.
The spoiler is actually a device associated with the aerodynamic vehicle. This device is designed with the main objective to reduce the negative effects of air currents moving at the time the car is running. Therefore, the main spoiler mounted on the vehicles used for racing at high speeds as well as in sports cars with high ability.

However, in practice, many ordinary passenger cars were also added spoiler just to boost the appearance of the vehicle without thinking of its main functions. Even with these efforts will indirectly get the fuel efficiency due to reduced air resistance.
Among automotive enthusiasts, there is often misguided between Spoiler with Wings.

Wings, actually serves to produce more “downforce” from the air flow through the device, not to alter the existing flow pattern. Spoiler while working to change the air flow through the area around the vehicle are moving, by directing air flow through a particular form.
Read the rest of this entry »